| Back
to the Omniterm Signal Conditioning Overview |
|
Omniterm
LPI
Model C2063
DIN rail mount single
loop-powered signal isolator Use the LPI loop
powered isolator to remove ground loops in 4-20mA current loops where
power is unavailable and there is sufficient spare volt drop in the loop
to accommodate the insertion loss. |
Omniterm
LPD
Model C2462
DIN rail mount dual
loop-powered isolator Use the
LPD dual loop powered isolator to remove grounds loops in multiple 4-20mA
loops where space is at a premium. The LPD incorporates the equivalent of
two LPI's in a single 22.5mm housing. |
|
Extremely low insertion loss
(2.5Volts typical) avoids loop overload. No field calibration means
lowest installation and commissioning costs. Load independence allows use
in two-wire transmitter loops. Operates over 0-50mA
see more information...
|
Extremely low insertion loss
(2.5Volts typical) avoids loop overload. No field calibration means
lowest installation and commissioning costs. Load independence allows use
in two-wire transmitter loops. Dual
circuit high density packaging for smallest space
see more information...
|
|
|
Omniterm
LPR
Model C2463
DIN rail mount Current
Loop Repeater (24Vdc powered). Use the LPR loop
repeater to increase the drive capacity of a 4-20mA loop. Connect the LPR
into an existing current loop and get a second isolated current loop that
mirrors the current of the first loop. |
Omniterm
LPS
Model C2464
DIN rail mount Current
Loop Splitter (24Vdc powered) Use the LPS Loop
Splitter to create two additional individually isolated current loops from a single
loop. The LPS is identical to the LPR, but has two outputs instead of one. |
|
Low insertion loss means that
the LPR will not overload the existing loop regardless of the load
connected to the output. Drive an additional 1kohm load
from an existing loop. Isolation of both input and
output ensures error free operation..
see more information...
|
Low insertion loss means that
the LPS will not overload the existing loop regardless of the load
connected to the output. Drive two additional 1kohm loads
from an existing loop. Isolation of both input and
outputs ensures error free operation..
see more information...
|
|
|
See the full range of Omniterm modules. |
